Back to Elegoo
¶
Resin printers
How to Handle Model Seams
How to remove supports effectively
How to repair model holes?
How to sand support points?
The Relationship Between Pixelation and Anti-Aliasing Blur
Model Orientation and Support Generation in CHITUBOX
How to deal with the resin in the trough if the printer is not used for a long time?
How to perform maintenance and upkeep?
How to slice via chitubox software?
Why the display screen is on but cannot be touched at all/touches are inaccurate?
Why the imported model is displayed in red/it displays the model has exceed the printing platform?
Why the printed model does not stick to the printing platform?
Why the printed model is incomplete/it breaks midway during printing?
Why the-printer-cannot-read-the-model-content-in-the-u-disk
Why there are obvious layers on the surface of the printed model?
The voxeldance lost authorization and need to be activated everytime?
What printer models support sliced files in .goo format?
What operating systems can chitobox run on?
What operating systems can tangle run o
n
What type of resin can be used with elegoo printers?
When do you need to add support to the model?
Which printer models can support .goo and .ctb format?
Why does the software respond very slow when slicing the model?
¶
FDM printers
My ABS filaments is not sticking to the hot bed?
Can it be printed online?
Why I got this issue that installing cure under windows and reports the lack of cpresponding syste, components?
Why there is no display on the touch screen?
Why the FDM printer stops at a fixed height during printing?
What should I do if I run out of filaments while printing the model?
What should I do if the POM wheel is fluffed?
What should I do if the X-axis direction of the printed model is misaligned?
What should I do if the Y-axiz direction of the printed model is staggered?
What should I do if the added support is difficult to remove?
What should I do if the edges of the printed model are warpped?
What should I do if the layers of printed model are too obvious?
What should I do if the printer does not recognize the memory card?
What should I do if there are gaps or obvious holes on the surface off the printed model?
What software can be used for FDM printers?