Back to Elegoo
¶
LCD Printers
Resin Printer Failed to Boot
Model Does Not Stick to the Build Plate
Poor or Bad Printing Quality: Model Layer Lines
Why Is the Display Screen On but Cannot Be Touched at All or Touches Are Inaccurate
Why Is the Imported Model Displayed in Red or It Displays That the Model Has Exceeded the Printing Platform
Why Does the Printed Model Not Stick to the Printing Platform
Why Is the Printed Model Incomplete or It Breaks Midway during Printing
Why Is the Printer Unable to Read the Model Content in the USB Flash Drive
Why Are There Obvious Layers on the Surface of the Printed Model
VoxelDance Lost Authorization and Needs to Be Activated Every Time
What Printer Models Support Sliced Files in .goo Format
What Operating Systems Can ChiTuBox Run On
When Do You Need to Add Support to the Model
Which Printer Models Can Support .goo and .ctb Formats
Why Does the Software Respond Very Slowly When Slicing the Model
How to Slice via ChiTuBox Software
LCD Screen Not Working
Print Failure
Limit Switch Abnormality
Unable to Read the USB Flash Drive
UV Light Not Turning On
Automatic Leveling Process for the Build Plate Did Not Succeed
Resin Heating Anomaly
Manual Leveling Process for the Build Plate Did Not Succeed
Mechanical Sensor Error during Self Test
WiFi Connection Fails
Self Test: Foreign Matter Detected
Self Test: Auto Leveling Failed
Self Test: X-Axis Motor Status Error
Printer Does Not Turn On
How to Perform Maintenance and Upkeep
How to Deal with the Resin in the Trough If the Printer Is Not Used for a Long Time
What Type of Resin Can Be Used with Elegoo Printers
How to Clean the Resin Cured on the LCD Screen
Resin Leakage
How to Handle Model Seams
How to Remove Supports Effectively
How to Repair Model Holes
How to Sand Support Points
The Relationship between Pixelation and Anti-Aliasing Blur
Model Orientation and Support Generation in ChiTuBox
¶
FDM Printers
Why Is There No Display on the Touch Screen
Why Does the FDM Printer Stop at a Fixed Height during Printing
What Should I Do If the POM Wheel Is Fluffed
What Should I Do If the X-Axis Direction of the Printed Model Is Misaligned
What Should I Do If the Y-Axis Direction of the Printed Model Is Staggered
What Should I Do If the Added Support Is Difficult to Remove
What Should I Do If the Edges of the Printed Model Are Warped
What Should I Do If the Layers of the Printed Model Are Too Obvious
What Should I Do If the Printer Does Not Recognize the Memory Card
What Should I Do If There Are Gaps or Obvious Holes on the Surface of the Printed Model
What Software Can Be Used for FDM Printers
¶
Filaments
What Should I Do If I Run Out of Filament while Printing the Model
My ABS Filament Is Not Sticking to the Hot Bed