PHECDA Wifi Antenna Assembly Replacement
Reference video
Tools and materials needed
●8mm open end wrench X 1
 |
Precautions before operation and machine status
●Please turn off the engraving machine and disconnect the power supply.
Operation Guide
Step 1 - Stand PHECDA up and move away the X axis;
 |
Step 2 - Use an 8mm open-end wrench to unscrew the fixing screw of the Wifi antenna and remove the Wifi antenna;
 |
 |
Step 3-Use an 8mm open-end wrench to unscrew the fixing screw of the Wifi antenna base and remove the Wifi antenna base;
 |
 |
Step 4 - Gently pull out the other end from the motherboard with your fingernail, and remove the Wifi antenna base cable;
 |
 |
Step 5 - Take out the new Wifi antenna base connection cable, snap the metal cap onto the motherboard connection port, press and fasten it, and put the other end into the PHECDA casing;
 |
 |
Step 6 - Install the fixing screws and washers to the Wifi antenna base and tighten with an 8mm open-end wrench;
 |
 |
Step 7 - Install the new Wifi antenna onto the antenna base and tighten it with an 8mm open-end wrench. The replacement of the Wifi antenna assembly is completed.
 |
 |