Jupiter SE-Constant Current Board Replacement
Tools and materials needed
●2.0mm Allen wrench
●2.5mm Allen wrench
●Constant current board
Reference video
Operation steps
1. Use a 2.0mm Allen wrench to loosen the 5 screws fixed on the right cover, and remove the right cover and motherboard light-blocking foam.
 |
 |
 |
2.Use diagonal pliers to cut off the hot melt glue on the cable port of the constant current board.
 |
 |
 |
 |
3. Use a 2.5mm Allen wrench to loosen the 4 screws fixing the constant current board and remove the constant current board.
 |
 |
4. Take out the new constant current board, align the screw holes, and place it in the mounting position.
 |
5. Use a 2.5mm Allen wrench to tighten the 4 screws fixing the constant current board.
|
|
|
|
6. Insert the cables connected to the constant current board.
 |
7. Align with the motherboard side ports to install the motherboard light-blocking foam, align the screw holes and place the right cover in the mounting position. Use a 2.0mm Allen wrench to tighten the five screws fixed on the right cover.
 |
|
|
8. Operate "[Tool]--[Exposure]--[Next]" on the touch screen. The printer's exposure screen will light up with the same pattern displayed on the touch screen, and you can use the printer normally.
 |
 |
 |
 |