Jupiter SE Build Plate Leveling
Tools and materials needed
●4.0mm Allen wrench
●Leveling card
●Dust-free cloth
●Alcohol
Reference video
Operation steps
1. Remove the automatic feeding device and resin bottle.
 |
 |
2. Turn counterclockwise to loosen the two hand-twist screws securing the resin tank and remove the resin tank.
 |
 |
3. Use a dust-free cloth dipped in alcohol to wipe and clean the LCD screen surface and the contact surface of the build plate to ensure that there is no foreign matter on the surface.
 |
4. Use a 4.0mm Allen wrench to loosen the 4 fixing screws of the build plate to about 1/3, to allow the build plate to move. (Note: Do not unscrew all the fixing screws, only loosen 1/3 so that the build plate can move freely)
 |
 |
 |
5. Take out the leveling card, place it on the LCD screen parallel, and align it with the build plate.
 |
 |
6. Operate "[Tools]", and "[Manual]" on the touch screen, click the "[Return to Zero]" button, and the printer will return to home.
 |
 |
 |
7. After homing movement is completed, hold the middle of the build plate with one hand, and use a 4.0mm Allen wrench to tighten the 4 fixing screws diagonally with the other hand.
 |
 |
 |
 |
8. After ensuring that the platform is flat, pull the leveling card until you feel slight resistance.
 |
9. Operate [Tools]-[Set Z=0]-[Confirm] on the touch screen.
|
|
 |
 |
10. Lift the build plate and install the automatic feeding device.
 |
 |
11. Install the resin tank and tighten the resin tank fixing screws (pay attention to the installation of the automatic feeding device), and you can print normally.
 |
 |