Jupiter SE-Automatic Feeding Device Instructions
Precautions
It is prohibited to forcibly move the resin feeding tube up and down by hand to avoid damage to the resin feeding module.
Tools to be used
●Resin (ELEGOO resin)
●Automatic feeding module
●Automatic feeding bottle cap module
Reference video
Operation steps
1. Unscrew the cap from the resin bottle (This cap is only suitable for ELEGOO resin bottles).
 |
2. Put the bottle cap with the detection rod into the resin bottle and tighten it (be careful to twist the bottle cap tightly to prevent air leakage).
 |
 |
3. Unscrew the 2 screws fixing the resin tank and remove the resin tank.
 |
 |
 |
4. Insert the automatic feeding device into the USB interface on the middle plate of the machine.
 |
 |
5. Align the resin tank with the holes and tighten the two fixing screws (Be careful not to press the two metal probes, and the pressing plate is behind the resin tank).
 |
 |
6. Insert the cable of the automatic feeding bottle cap module into the port at the rear of the automatic feeding device.
 |
 |
7. Insert the black rubber tube of the automatic feeding device into the thicker interface of the resin bottle cap, and insert the transparent rubber tube into the thinner interface of the resin bottle cap (Note that the rubber tube must be inserted tightly).
 |
8. Plug in the power cord and turn on the printer.
 |
9. Click [Settings]-[Resin Feeding Settings], select [Medium Speed], and open [Resin Feeding Status].
 |
 |
 |
 |
 |
10. Insert the USB flash drive with the "slice file" saved into the printer, select the slice file to print, and the machine will start feeding resin automatically.
 |
 |
11. Wait until the resin level exceeds two probes to complete the resin feeding, and the machine will automatically start printing.
 |
 |
12. During the printing process, when the resin level is lower than the two probes, the automatic feeding device will automatically refill.
 |
13. After printing is completed, click [Settings]-[Automatic Resin Recycling] on the main page to recycle the resin in the resin tray.
|
|
|
|
|
|
14. After the resin recycling is completed, click [Stop Recycling] on the screen to clean up the residual resin in the resin tank.
|
|