A 2.0 mm Allen key
A 2.5 mm Allen key
A new cooling fan

Turn the power switch OFF (symbol "〇") and unplug the power supply cable.
Unplug the cable of the automatic resin feeding inlet.

Remove the clamp and unplug the automatic resin feeding tube.
Note: Hold the automatic resin feeding tube and keep the tube upward to prevent the resin from dripping.


Remove the automatic resin feeding bottle and put it on the table temporarily.

Secure the automatic resin feeding tube with a cable tie to avoid the resin drips.

Release and remove the five screws securing the right cover with a 2.0 mm Allen key and remove the right cover.

Unplug the cable on the motherboard.

Release and remove the five screws securing the left cover with a 2.0 mm Allen key and remove the left cover.


Open the front door.

Lift the automatic resin feeding inlet.

Seal the inlet with a bag and a cable tie to avoid the resin drips.

Remove the two knob screws.

Remove the resin tank.

Close the front door.

Put the printer on its left side.

Release and remove the three screws securing the power supply with a 2.5 mm Allen key.
Note: Hold the power supply when releasing the last screw.

Turn the power supply over and put it above the chamber temporarily.

Release and remove the three screws securing the cooling fan with a 2.0 mm Allen key.

Remove the old cooling fan.
Get the new cooling fan and put it in the installation position. Pass the cooling fan cable through the hole.

Tighten the three screws securing the cooling fan.

Put the power supply in the installation position.

Tighten the three screws securing the power supply.

Put the left cover in the installation position and tighten the five screws securing the left cover.

Plug in the cooling fan cable.

Put the right cover in the installation position and tighten the five screws securing the right cover.

Cut off the cable tie securing the automatic resin feeding tube.

Install the automatic resin feeding bottle in its position.
Note: Hold the automatic resin feeding tube and keep the tube upward to prevent the resin from dripping.

Insert the automatic resin feeding tube. Install the clamp of the tube.


Plug in the cable of the automatic resin feeding inlet.

Open the front door.

Get the resin tank and put it in the installation position.

Tighten the two knob screws.

Remove the bag and the cable tie.

Restore the automatic resin feeding inlet.

Plug in the power supply cable. Turn the power switch ON (symbol "|").
The printer is ready for use after the self check.
